Instructions / Assembly

17
iVECTOR Heater/Cooler
12.0
12.0 Control System Set-up and Operating Instruction
11.0
General Description
The electronic control system on this unit provides a wide range
of options that can be selected according to system complexity
and operating requirements.
The unit is factory set to ‘Easy mode’ giving thermostatic
temperature control, fan only option and clock function.
Additional functions are available if necessary from the Full
operating mode menu.
A range of additional parameters and features can be changed
or activated in a further set up menu should these be required.
Easy Mode
Turn on Electrical Supply
Easy Mode
(Factory Default)
Full Mode
Use ( ) and ( ) keys to select
operating mode (Refer to
section 12.2 for details)
Setup Parameters
(Refer to section 12.3
for details)
Select Clock
Set Time
Full Mode
Select Comfort Setting
Set room temperature to
desired setting (default 21°C).
Fan runs in heating/cooling
Fixed fan setting
Comfort setting
Clock function
Power on/off
Fixed fan setting
Comfort setting
Auto setting
Setback setting
Frost setting
Power on/off
Clock function
Program setting
Auto
P
Press & hold (+) & (-) for 5 secs
to change between modes
Press & hold (+) & (-)
for 5 secs to change
between modes
Select Auto mode and
press (OK) for 10 secs
12.1 Unit Operation
Use ( ) and ( ) keys to choose from the operating modes
described in section 12.2. A function is selected when the
relevant icon is highlighted by .
25278 iVector Installation Guide US 02/01/2013 09:25 Page 18