Specifications

Step 1 Locate studs in wall where the radiator is to be mounted.

Step 2 Mount the brackets so the radiator is a minimum of 4 inches off the floor.

• Failure to allow 4” minimum clearance below radiator can significantly reduce

radiator performance.

• Attach brackets firmly to the studs using appropriate hardware making sure

the spring loaded connection on brackets is on top.

•

All Select Radiators use 2 brackets except as noted on page 9.

• Use a level to assure bracket is plumb.

Step 4 To install the radiator on the brackets, set the bottom edge of the rear panel on the bottom

part of the bracket then gently lift and snap the top clip into the grille of the radiator.

Many MYSON products are in excess of 70 pounds. Care should be taken to have help to lift

larger radiators into place to avoid lifting injuries.

T6 Radiator Series

Conventional Wall Installation Using Optional EZ-Brackets

)

NOTE: For mounting instructions of the T6 radiator using the new style EZ

brackets please refer to the instructions included with the brackets.

Step 3 Position radiator to line up with the supply and return pipes.