Operating instructions

QUESTIONS? PROBLEMS? PLEASE CALL YOUR DEALER FOR HELP.
18
SYSTEM SETTINGS (Monaco Only)
When your spa is first actuated, it will go into Priming mode, indicated by “Pr.” The Priming
mode will last for less than 5 minutes (press “Warm” or “Cool” to skip Priming Mode) and then
the spa will begin to heat the spa and maintain the water temperature in the Standard mode.
The start-up temperature is set at 100°F/37°C. The last measured temperature is constantly
displayed on the LCD. Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
To display the set temperature, press the “Warm” or “Cool” pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing.
Each press of the “Warm” or “Cool” pad will continue to either raise or lower the set temperature.
After three seconds, the LCD will stop flashing and display the current spa temperature.
Jets
Touch the “Jets” button once to turn the pump on or off, and to shift between low and high
speeds. If left running, the low speed of the pump will automatically turn off after 4 hours, and
the high speed will automatically turn off after 15 minutes.
Light
Press the “Light” button to turn the light on and off. If left on, the light automatically turns off after
4 hours unless manually turned off prior to 4 hours.