Operating instructions

19
Preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins
12 hours later. Filter duration is programmable for 2, 4, 6, 8 hours or for continuous filtration
(indicated by “Filc”). The default filter time is 2 hours.
To program, press “Warm” or “Cool”, then “Jets”.
Press “Warm” or “Cool” to adjust. Press “Jets” to exit programming.
During the filter cycle, the low speed on the pump never turns off, and in Economy and Sleep
Mode, heating only occurs during the filter cycle.
To program, press WARM, then JETS. Press WARM to adjust from 2 -8. Press JETS to exit
programming. The default filter time is two (2) hours.
Waterfall Flow adjustment will adjust the amount of
water coming out of the waterfall. You can adjust it
from OFF to FULL power.
Remote pump controls, there are 2 of these
buttons to control your pumps. You can switch
the pumps from HI to LO by pressing these
remote buttons. They are located next to each
water diverter.
Turning the air control knobs will adjust the amount of air pressure coming out of the jets. You
can adjust them from MINIMAL to FULL power. Turning the water diverter knobs from left to
right will divert the water pressure from seat to seat in the tub.
AIR CONTROL & WATER DIVERTER VALVES