User's Manual

MYSPHERA • Ronda Auguste y Louis Lumiere 23, Nave 13 • 46980 Parque
Tecnológico de Valencia • Paterna, Valencia • Spain
Telf.: [phone] • [e-mail] • www.mysphera.com
Pág. 9
This device can be put into service and used without restrictions in several European Union
countries (BE / DE / ES / FR / GR / IT / NL / NO / UK)
9. Declaration of conformity
http://www.mysphera.com/declaration-of-conformity
9.1. CE Mark
MySPHERA declares that this device complies with the requirements and
specifications set out in Directive 2014/53 / EU (RED).
9.2. FCC Mark
This device complies with the Part 15 B specification of the FCC Rules.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
9.3. Updating device
The programming and functionality of the hardware and firmware are carried out at the
factory complying with the essential requirements of the product.
The end user cannot make any modification of the FW / SW or functionality or have any
button, connector or element that allows changing any parameter that affects the correct
functioning of the product or the fulfillment of its essential requirements.
If any update, change or special modification of FW is required, the product must return to
Mysphera. You cannot vary operating parameters automatically or remotely.