User manual

16
1003DX SPEEDSTER
®
SWITCHES
“On” switches are located on the plate in front of the machine. To
use vacuums, turn on Vac 1 and Vac 2 switches. To use pump,
turn on Pump switch. To activate heat, use lower right switch.
Press to the left for 1,000 watts, press to the right for 2,000 watts.
1003DX SPEEDSTER
®
FILL SOLUTION TANK
Lift lid and manually ll the tank.
1003DX SPEEDSTER
®
VAC/SOL
HOSE CONNECTIONS
Attach one end of a solution hose to a wand or other tool, the other
end to the Speedster’s® front quick disconnect. Attach one end of
a vacuum hose to the tool, the other end to the Speedster’s®
Cuff-Lynx™ vacuum hose port.
1003DX SPEEDSTER
Pump
Heater
1 2
Vac 1 Vac 2
1003DX SPEEDSTER
®
PRIME VALVE
& PRESSURE REGULATOR
Prime the pump by turning the valve to the Prime position (as
shown above) for 30 seconds, then turn right to the Run position.
Turn the Pressure Regulator to the left to decrease water pres-
sure. Turn the Pressure Regulator to the right to increase water
pressure.
PRESSURE
REGULATOR
HIGHER PSI
LOWER PSI
Speedster Prime Label
RUN POSITION
PRIME POSITION