Operating instructions

SPEEDSTER

LTD3 PRIME VALVE &

PRESSURE REGULATOR

SPEEDSTER

LTD3 VAC/SOL

HOSE CONNECTIONS

Attach female end of a solution hose to a wand or tool and the

male end to the LTD’s QD. Then connect a vacuum hose to a

wand and the 2” male Cuff-Lynx™ hose port. (If using the optional

de-foamer, install the kit onto the vacuum port according to the

instructions that come with the de-foamer kit.)

SPEEDSTER

LTD3 SWITCHES

To use vacuum, turn on Vac 1 and Vac 2. To use pump, turn on

Pump. To use pump-out, turn on Pump-Out switch. To use Heater,

turn on Heater. Release tool trigger. Wait 8 – 10 minutes for unit

to pre-heat. Once heated, re-key upholstery tool until hot water

begins owing. Once hot water is owing, release trigger and

pre-heat an additional 4 – 5 minutes.

Vac 1 Vac 2 Pump

Pump

out

SPEEDSTER

LTD3 FILL SOLUTION TANK

You can lift the lid to manually ll the tank or follow the “Operating

Instructions” for auto-ll use.

Heater

SPEEDSTER® LTD3

Prime the pump by having the Prime Valve parallel with its pipe

and turn it clock-wise to run the pump. Turning the Pressure Regu-

lator to its left will decrease water pressure and turning to the right

will increase water pressure.

*Please refer to the Pressure Gauge to monitor your water pressure.