User manual

Switches and Pressure Gauge are located on the plate in front

of the machine. The Amber light left of the Pressure Gauge will

illuminate when cords are plugged into two separate circuits. To

use vacuums, turn on Vac 1 and Vac 2 switches. To use Pump-out,

turn on Pump-out switch.

To use on carpet, turn the Pump Mode switch

to Carpet. To use for Tile, turn the Pump Mode switch to Tile.

The Pres-

sure Gauge displays the water pressure as PSI.

M-12 SWITCHES & PRESSURE GAUGE

VAC 1

VAC 2

PUMP OUT

PUMP MODE

CARPET TILE

M-12 VAC/SOL HOSE CONNECTIONS

M-12 CARPET MODE

Press left side of Pump mode button for Carpet. The Amber light left of the Pressure Gauge will illuminate when cords are plugged into two

separate circuits. Two red lights left of switches will appear when Carpet mode is activated. In carpet cleaning mode, a 220 PSI pump and

solution heater are used. The 220 PSI is not adjustable. Adjusting the regulator in this mode will not affect the pump pressure.

Before turning on switches, connect hoses to the extractor and a

wand or tool. Attach a solution hose to the front QD, the other end

to the tool. Attach a vacuum hose to the tool, the other to the front

Cuff-Lynx™ vacuum hose port. Just twist into place.

PUMP MODE

CARPET