User manual

3
M-3 SWITCHES & PRESSURE GAUGE
Switches and Pressure Gauge are located on the plate in front
of the machine. The Amber light left of the Pressure Gauge will
illuminate when cords are plugged into two separate circuits. To use
vacuums, turn on Vac 1 and Vac 2 switches. To use Pump, turn on
Pump switch. Heater switch has three positions: Off (middle); 1,000
watts using one heater (left); and 2,000 using two heaters (right).
Red lights on panel display indicate watts selected: one light =
1,000 watts; two lights = 2,000 watts; no lights = heater is off.
VAC 1
VAC 2
PUMP
HEATER
M-3 VAC/SOL HOSE CONNECTIONS
Before turning on switches, connect hoses to the extractor and a
wand or tool. Attach a solution hose to the front QD, the other end
to the tool. Attach a vacuum hose to the tool, the other to the front
Cuff-Lynx™ vacuum hose port. Just twist into place.
M-3 AUTO-FILL & PUMP-OUT
If using Auto-ll and Pump-out, connect one end of a 1/2 inch
garden hose to the top hose inlet in back of the machine, the other
end to a faucet. Add water pressure by turning on faucet. Attach a
second 1/2 inch garden hose to the bottom hose inlet, and place the
other end in a location where dirty water can drain. Turn on Pump-
out switch. When job is complete, turn off Pump-out switch.
AUTO-FILL
PUMP-OUT
M-3 FILL SOLUTION TANK
If not using the Auto-ll feature, lift the solution tank lid and manually ll
the tank.
PUMP-OUT
M
-
3 M-SERIES™