User guide

Mytek PQ Multichannel System – User's Manual
Fixed Inatallation
Fixed installation is recommended for a single room studio where the
system is permanently installed. Usually the distribution rack sits in
one place in the studio and is connected with the patchbay of the
console using single 16 pair permanent cable terminated with a
Centronics connector. The patchbay has 12 (or 15 if the remote is
used) patchpoints designated for all 12 inputs of the system. The
same type of installation can be used in a multiroom facility but
requires repeated wiring in all studios.
If there are isolation booths in the studio an elegant solution is to run
a booth extension cable for each booth (see "Accesories").
User Manual ver. 1.0 / Jun 2013 www.mytekdigital.com Page: 7 / 14
ISOLATION BOOTH
PQ BOX
PQ BOX
PQ BOX
PQ BOX
PQ RACK
STUDIO
AC POWER
CONTROL
ROOM
THE STATION IN THE ISO BOOTH USES
PERMANENTLY INSTALLED CABLE
EXTENSION
THE SYSTEM IS FED FROM THE PATCHBAY
USING PERMANENTLY INSTALLED CABLE.
THIS CABLE ALSO CARRIES OUTPUT SIGNALS
FROM THE STATIONS AND CONTROL SIGNAL
FOR THE REMOTE.
PATCHBAY