User manual

Mytek Ptools-HD DIO Card – User Manual
Output
To playback signal from Protools to converter analog outputs
SOURCE TO ANALOG OUT should be selected. If SOURCE TO
DIGITAL OUT is set to DIOCARD1 as well, audio is relayed
from the Pro Tools system to the converter DAC (analog out) as
and to AES?EBU outputs as well as other digital outputs if
installed.
The actual signal flow in the 8X192ADDA is available in the
form of schematics in the 8X192ADDA manual.
The Protools tracks to be sent to the 8192 ADDA can be
selected in the ProTools software. In Setup > I/O Setup you can
assign interfaces to signal outputs, later assigned to tracks in the
Pro Tools application.
While track outputs are assigned to channels in the Protools
software, the actual signal routing of the incoming 8 channel to
the converter physical inputs and outputs must be done
manually on the converter front panel ( SOURCE TO ANALOG
OUT and SOURCE TO DIGITAL OUT). This routing may
initially appear confusing, but after studying the signal flow
diagram in the 8X192ADDA manual you will find it makes a lot
of sense by providing very useful system flexibility.
Editing panel – assigning output
channels
User Manual ver. 1.0 / jan 2007 www.mytekdigital.com Page: 16 / 29