User manual

Mytek Ptools-HD DIO Card – User Manual
Launch and Configuration
After the cardinstallation in the converter, and after each
hardware configuration change, interface controls must be
configured in the Pro Tools application during the first launch.
This is performed the following way:
1. Double check the cables connecting the converter with
the Pro Tools card are properly attached.
2. Turn the converter on.
3. Check if clock signals are properly configured and active
(solid lock, in case they are transmitted from an external
device).
4. Launch the Pro Tools application.
5. In Setup > Hardware Setup check if attached converters
were properly detected. 8×192 ADDA Mytek Converter
with Ptools DIO-HD card is detected as 192/IO in the
Pro Tools system.
Setup > Hardware Setup
When the Pro Tools
applicatin is running do not
turn the converter on or off.
Always quit the application
before turning off converter.
Take special precautions
and turn down the output
or volume to the amplifier
and speakers while
launching the ProTools
application.
User Manual ver. 1.0 / jan 2007 www.mytekdigital.com Page: 17 / 29