User manual

Mytek Ptools-HD DIO Card – User Manual
6. Select each converter and press Set to Default to set the
application in the normal work mode.
7. In Setup > I/O Setup configure the routing according to
your needs, while keeping in mind the 8×192 ADDA
converter has only eight channels.
Setup > I/O Setup
If converter is not attached to the Pro Tools systems, it can be
used as a standalone device, as if no DIO-HD card was
installed. DIO-HD card is disabled until it is connected to the
Pro Tools systems and the application is launched on a
computer.
When the application is launched, control over converter’s
sampling frequency is assigned to software. It is the only
available option in Setup > Hardware Setup which influences
converter’s configuration. Other settings, such as selection of
input or format of digital signal are ignored and should not be
changed. Before launching the application pay special attention
to clock signal source setting in the converter.
Remember that 8x192
ADDA converter has eight
channels. Selecting
channels 9-16 as audio
sources will result in no
signal (silence).
Setup > Hardware Setup
User Manual ver. 1.0 / jan 2007 www.mytekdigital.com Page: 18 / 29