User manual

Mytek Ptools-HD DIO Card – User Manual
Card Installation
Only single Ptools-HD DIO Card can be installed in one
converter. A different format card can be installed in second
slot. Card must be installed in the DIOCARD1 slot, which is
first from the right at the converter’s rear panel.
8x192 ADDA converter’s rear panel
WARNING!
Remember to follow basic safety rules about handling of
electronic devices while opening the converter:
✔ keep your hands dry,
✔ turn off power and detach power and signal cables
while working with the top cover removed.
To install DIO-HD card:
1. Find the DIOCARD1 expansion slot at the mainboard’s
layout
2. Check if the power cord and all signal and clock lines
are disconnected. Remove top cover.
Before you install the card
in the converter, check if
converter’s firmware
supports DIO-HD card
(version v.2.2.9 or later). If
not, contact your Mytek to
request current version.
User Manual ver. 1.0 / jan 2007 www.mytekdigital.com Page: 7 / 29