User manual
myth 
Preamplifier user manual
myth www.myth.rs  
11 / page
6. Using the remote controller 
 Myth Preamplifier is equipped with a remote controller unit. 
 The  remote  controller  unit  uses  4xAAA  batteries  the  life  of  which  is 
expected to be 2 years under normal usage of the controller. The LED in 
the top left corner is used as indicator of battery health and as soon as it 
fades during operation, the battery set should be replaced. 
 It is recommended to use only alkaline batteries. 
 It is recommended to replace old batteries only with a new battery set. 
 The  remote  controller uses  standard  Philips  RC5  infrared  coding for 
sending commands to the Myth Preamplifier. In case the remote controller 
unit is damaged or lost it can be replaced with any compatible Philips RC5 
remote controller unit, or users can contact the Myth office for getting the 
original remote set. 
 The remote controller unit consists of 6 buttons with the following 
functions: 
 1. Previous Input 
 2. Next input 
 3. Volume Down 
 4. Volume Up 
 5. Mute/Unmute 
 6. Stand by 
 Pressing any of the buttons will cause appropriate action. 
6.1. To power up the device using Remote controller 
 Pressing  the  "Power"  button  on  the  remote  controller  will  cause  the 
device  to  power  up.  After the  device  is  initialized  and  has  reached  a 
steady  state  it  is  possible  to  turn  it  off  by  pressing  the  "Power"  button 
again. 
 Once in stand by state it is necessary to wait for at least three seconds 
while the unit responds again to a command from the Remote Controller. 
This  delay is  introduced  for  safety reasons  and  to  prevent fuse from 
burning due to peaks caused by fast switching of the mains power supply. 
6.2. To select input using the Remote controller 
 - Using buttons "Previous Input"  and "Next Input"  on the remote 
controller it is possible to change desired audio input. 
 If the "Previous Input" button is pressed the input selection changes in 
the following order: 
 AUX - PC - TUNER - DVD - CD 
 If the "Next input" button is pressed the input selection changes in the 
following order: 
 CD - DVD - TUNER - PC - AUX 










