Installation Instructions

Power Meter Location
Before use, take out the battery insulation sheet
Replace battery
* LED Flash colors: Battery install successful
* Green LED flash 3 seconds : Bluetooth connected
* Battery type: CR2032 coin battery
❶ Use your finger or nail to align the battery door paddle and
turn the battery door in the direction indicated by the arrow;
❷ After removing the battery insulation sheet, put the battery
cover (including the battery) into the battery compartment;
❸ Pay attention to the alignment of the battery door paddle
as shown below;
While pressing the battery door inward, align your finger
or nail on the battery door paddle and reverse the
direction indicated by the arrow,push, the LED light on the
side of the sensor flashes to indicate that the installation
is correct.
Power Meter
Location
Battery
Metal battery bracket
Battery door
Align the triangle
arrow and put it in
take out the battery
insulation sheet
Do not allow children to touch the battery
to avoid danger, The product has a built-in
battery. Do not throw the product into a fire.
❷ Take out the battery door, find the metal battery
bracket in the battery door, remove the bracket,
you can take out the old battery and turn the
positive side of the new battery toward the metal
bracket.and put it into the battery door, and install
battery door into battery compartment as the
steps above.
❶ Use your finger or nail to align the battery door paddle and
turn the battery door in the direction indicated by the arrow.
LED
flash
keep pressing
battery door
with your finger
Align the side of
slot and press
❸ Pay attention to the alignment of the battery door paddle
as shown below;
While pressing the battery door inward, align your finger or
nail on the battery door paddle and reverse the direction
indicated by the arrow,push, the LED light on the side of the
sensor flashes to indicate that the installation is correct.
LED
flash
keep pressing
battery door
with your finger
Align the side of
slot and press