Installation Guide

Cloth
Connector
A
B
A
A
B
B
C
2
C
C
B B B
3
4
5
6
B
B
7
8
A
B
adjust the leveler
B
A
Corner hole top and
botto m difference
B
A
A
The bigger diameter
downward
A ssem b l Iy n st r u ct ions
Use a pen to mark the height on the 4 Poles (B) with levelers.
Be sure all poles are marked in the same location.
Attach 2 Spacers (C) at the pen marks on the 4 Poles (B).
Keep the arrows on the spacers (C) pointed upwards.
Place the Poles (B) with levelers through the corner holes of 1
Shelf (A).Fit the shelf carefully and securely over the Spacers (C).
Install the second Shelf (A) following steps 2-3.
If it is 2-section or 3-section pole,screw the Pole (B) onto the
threaded ends of the installed Poles (B). Be sure the
connection is secure & tight.
Install remaining Shelves (A) following steps 2-3.
Use the rubber mallet to tap the shelves into place for a secure fit.
Use a soft cloth between the shelf & mallet to prevent damage to
the shelf.
Assembly is Completed.
See the assembly photo with different tier shelves for your reference.
3-Tier wire shelving 4-Tier wire shelving 5-Tier wire shelving 6-Tier wire shelving