Installation Guide

Shelves

Poles

Spacers

1.Before beginning assembly of product, make sure all parts are present. Compare parts with package contents

list and hardware contents . If any part is missing or damaged, do not attempt to assemble the product.

2.Estimated Assembly Time: Approximately 15 - 25 minutes.

3.Helpful Tools (not included):Rubber Mallet.

4.Decide on the shelf location before beginning the assembly.Once the Product is assembled,it is very difficult to

move a shelf without taking the entire assembly apart and starting over.

5.No Tools Required for Assembly.

Part Description Picture

CARE AND MAINTENANCE

NOTICE

- Two adults required for a assembly.

- Do not allow children to climb or play in or around the shelves.

- Assemble on a soft surface, such as carpeting to avoid scratching the finish.

PREPARATION

Never use abrasive or acid-based cleaners on the shelf rack.

Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to wipe

parts. Rinse and dry thoroughly. Keep surfaces dry and clean for a longer lasting finish.

Please read and understand these instructions before attempting to assemble, operate or install the product.

Reference Photo

www.lowes.com

PAGE 1
CARE AND MAINTENANCE Never use abrasive or acid-based cleaners on the shelf rack. Clean shelves and rods with a solution of mild detergent and water. Use a soft cloth or sponge to wipe parts. Rinse and dry thoroughly. Keep surfaces dry and clean for a longer lasting finish. NOTICE Please read and understand these instructions before attempting to assemble, operate or install the product. - Two adults required for a assembly. - Do not allow children to climb or play in or around the shelves.
PAGE 2
A ssem b l y I n st r u ct i ons 2 B 3 C B A C C Corner hole top and bottom difference A B B Use a pen to mark the height on the 4 Poles (B) with levelers. Be sure all poles are marked in the same location. 4 A A B B Attach 2 Spacers (C) at the pen marks on the 4 Poles (B). Keep the arrows on the spacers (C) pointed upwards. 5 Place the Poles (B)with levelers through the corner holes of 1 Shelf (A).Fit the shelf carefully and securely over the Spacers (C).