Switch User Manual

(Revised 2010-7-2) page 12 of 145
DIN-Rail Mounting
Install the unit on a standard 35mm Din-Rail. Recess the unit to allow at least 5” of horizontal clearance for fiber cable bend
radius.
To mount the unit to the 35mm din-rail, place top edge of the
bracket on the back of the unit against the din-rail at a 45° upward
angle. Lower the bottom of the unit until it snaps into place.
To remove the unit from the 35mm din-rail, place a
flat head screwdriver into the release clip at the bottom of
the unit, and push down on the clip until it disengages
from the bottom of the unit from the din-rail. Lift the
bottom of the unit up at an approximate 45° upward angle
to completely remove the unit.
Most N-Tron™ products are designed to
be mounted on industry standard 35mm DIN-
Rail. However, DIN-Rail mounting may not
be suitable for all applications. Our Universal
Rack Mount Kit (P/N: URMK) may be used
to mount the 9000 Series to standard 19"
racks as an option.