Instruction Manual

ManualsBrandsNaceCare Solutions ManualsWater equipmentAV12QX

Owners Manual for the AV12QX

PRIOR TO USING THIS MACHINE, MAKE SURE THAT YOU HAVE READ, AND

UNDERSTAND THE SAFETY AND OPERATING INSTRUCTIONS FOR THIS MACHINE.

NaceCare Solutions

1205 Britannia Road East

Mississauga, Ontario, Canada

L4W 1C7

Toll Free: 1 800 387 3210

Toll Free Fax: 1 800 709 2896

Summary of content (7 pages)

PAGE 1
Owners Manual for the AV12QX PRIOR TO USING THIS MACHINE, MAKE SURE THAT YOU HAVE READ, AND UNDERSTAND THE SAFETY AND OPERATING INSTRUCTIONS FOR THIS MACHINE.
PAGE 2
Safety instructions (read carefully) Every electrical device must be used for its particular function only, respecting the manufacturer’s instructions. Failure to adhere to these instructions could result in serious bodily injury to the operator (shock, electrocution, etc.). Please read the following safety instructions carefully and ensure that you understand them prior to using the machine.
PAGE 3
SETUP This machine is designed to clean large areas of carpet. For normal operation, the machine drives forward, cleaning a path of 20 inches of carpet (see Using as a Self-propelled Machine). It can also be used to clean small areas of carpet, with an additional hose and floor wand (see Using with Accessories) The following steps explain how to prepare the machine for use: 1.
PAGE 4
Using as a Self-contained Extractor Water-flow adjustment knob Foot pedal for vacuum shoe Vacuum shoe pressure adjustment Brush height adjustment 1. This machine is capable of being converted to a scrubber/dryer with an optional hard floor squeegee (P/N#18270E). 2. Lower the brush by turning the brush height adjustment knob counter clockwise. For carpet, the recommended setting is the second last notch. If using on hard floor, lower the brush all the way down.
PAGE 5
CONTROL PANEL TOP VIEW PUMP II O O O I I I VACUUM BRUSH SOLUTION CONTROL 4. Turn the vac motor, and brush motor switches to the “I” position. 5. Set the pump switch to the “I” position. In the “I” position, the pump will only work when the solution control lever is engaged. 6. On the lower left side of the machine, you can adjust the water flow by turning the ball valve knob. Turning the knob clockwise reduces the water flow. Turning the knob counter clockwise increases the water flow.
PAGE 6
Vacuum hose Solution hose 2. Connect the longer vacuum hose to the machine 3. Connect the longer solution hose to the machine 4. Switch on the vacuum motor by setting the switch to the "I" position. 5. Turn the pump to the "II" position. In this position, the solution pump is always on. 6. To spray water you need to pull the lever situated on the handle of the floor wand or hand tool.
PAGE 7
AFTER USE, FOLLOW THESE STEPS 1. Empty solution tank. 2. Put some fresh water in the solution tank and pump this through the system. This will help keep the pump system clean. 1. Clean the recovery dome and gasket. 2. Thoroughly rinse and drain the recovery tank to prevent odors from developing. 3. Run the vacuum motor for 1 to 2 minutes. This will help remove any moisture from the motor fans and fan casing. 4. When storing the machine, make sure to leave the recovery dome off of the machine.