Owner's Manual
CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No sound.
• Power AC lead unplugged or power not
switched ON.
• Check if AC lead is plugged in and power
switched ON.
• Mute on. • Switch o Mute.
No sound one channel.
• Balance control not centered. • Center Balance control.
• Speaker not properly connected or damaged. • Check connections and speakers.
• Input lead disconnected or damaged. • Check leads and connections.
Weak bass/diused stereo image. • Speakers wired out of phase.
• Check connections to all speakers in the
system.
Remote control handset not working.
• Battery at or incorrectly inserted. • Check or replace battery.
• IR transmitter or receiver windows obstructed. • Remove obstruction.
• IR receiver in direct sun or very bright ambient
light.
• Place unit away from direct sun, reduce
amount of ambient light.
Standby LED turns red during operation.
• C 316BEE has overheated.
• Turn C 316BEE OFF; make sure ventilation
slots on top and bottom of C 316BEE are not
blocked. After C 316BEE has cooled down,
turn back ON.
• Overall impedance of loudspeakers too low.
• Ensure the overall loudspeaker impedance is
not below 4 ohms.
REFERENCE
TROUBLESHOOTING
10
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ