Owner's Manual
USING THE AMP 1 REMOTE CONTROL
The AMP 1 remote control handset handles the key functions of the C 316BEE. It has additional
controls to remotely operate NAD CD Players. It will operate up to a distance of 23ft (7m). When a
command from the remote control is received, the Standby LED indicator will blink.
1 POWER ON & OFF: The AMP 1 remote has a separate ON and OFF button. Press the ON button
to switch the unit from Standby to operating mode. Press the OFF button to switch the unit to
Standby mode.
2 MUTE: Press the [MUTE] button to temporarily switch OFF the sound to the speakers or
headphones. MUTE mode is indicated by the Standby LED indicator ashing. Press MUTE again to
restore sound.
3 VOL : Press [VOL ] button to increase or decrease the loudness level. Release the button
when the desired level is reached. The VOLUME buttons do not aect recordings made using the
TAPE output.
4 INPUT SELECTORS: Refer to the corresponding labels printed on the assigned remote control
buttons to make use of these functions. The input selector buttons perform the same functions as
the buttons labeled the same on the front panel.
5 CD PLAYER CONTROL (for use with NAD CD Player): Some of the control buttons below are
applicable only to specic NAD CD Player models; check the owner’s manual of your NAD CD
Player for control button compatibility.
: Stop playback.
: Pause playback temporarily.
: Start playback.
: Open or close disc tray.
: Go to next track or le.
: Go to the beginning of current/previous track or le.
IDENTIFICATION OF CONTROLS
AMP 1 REMOTE CONTROL
11
2
4
5
3
1 1
2 3
4
5
9
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ