Owner's Manual

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS

No sound. • Power AC lead unplugged or power not

switched ON.

• Check if AC lead is plugged in and power

switched ON.

• Tape Monitor selected. • De-select Tape Monitor mode.

• Mute on. • Switch o Mute.

• Rear Pre-out/Main-in amp links not tted. • Fit links.

No sound one channel. • Balance control not centered. • Center Balance control.

• Speaker not properly connected or damaged. • Check connections and speakers.

• Input lead disconnected or damaged. • Check leads and connections.

Weak bass/diused stereo image. • Speakers wired out of phase. • Check connections to all speakers in the

system.

Remote control handset not working. • Battery at or incorrectly inserted. • Check or replace battery.

• IR transmitter or receiver windows obstructed. • Remove obstruction.

• IR receiver in direct sun or very bright ambient

light.

• Place unit away from direct sun, reduce

amount of ambient light.

Standby LED turns red during operation. • C 375BEE has overheated. • Turn C 375BEE OFF; make sure ventilation

slots on top and bottom of C 375BEE are not

blocked. After C 375BEE has cooled down,

turn back ON.

• Overall impedance of loudspeakers too low. • Ensure the overall loudspeaker impedance is

not below 4 ohms.

REFERENCE

TROUBLESHOOTING

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ