Owner's Manual
ADDENDUM SHEET FOR C426
USING THE NEW TNR 1 REMOTE CONTROL
1 ON: Power up C 426 from standby mode.
2 OFF: Switch C 426 to standby mode.
3 0-9 number buttons: Direct-entry of frequency channel or Preset
number.
4 10+: Switch between AM and FM band.
5 DISP: Show RDS PS, RDS PT, Preset name or station frequency as
applicable.
6 SLEEP: Set sleep mode timer.
7 PRESET: Step up or down Preset numbers.
TUNE: Tune forward or backwards.
ENTER: Not applicable for C 426.
8 FM: Select FM band.
9 AM: Select AM band.
10 BLEND: Activate or deactivate BLEND feature.
11 DIMMER: Reduce, restore or turn o VFD brightness.
12 FM MUTE: Activate or deactivate FM MUTE FM STEREO mode.
DISP
PRESET
TUNE
ENTER
TUNE
PRESET
BLEND FM MUTE
TNR 1
DIMMER
SLEEP
FM AM
1 2 3
4 5 6
7 8 9
0 10+
4
6
3
5
1 2
4
6
9
3
5
7
8
10 11
12
SLEEP MODE
The Sleep Mode timer will switch the C 426 to standby mode automatically after a preset number of minutes. Toggle TNR 1’s [SLEEP] key to select through the
following Sleep mode timer settings – SLEEP 30, SLEEP 60, SLEEP 90 and OFF. Stop at the desired Sleep mode timer setting. A corresponding “SLEEP” icon will
be illuminated in the VFD.
While at SLEEP time mode, pressing the TNR 1’s [SLEEP] button once will display the remaining minutes (i.e. “SLEEP _ _”; “_ _” is the number of minutes
remaining) before the C 426 goes to standby mode.
To cancel the sleep mode, continue pressing the TNR 1’s [SLEEP] button until “OFF” is displayed on the VFD. Switching the C 426 to standby mode from either
the TNR 1’s [OFF] button or the front panel Standby button will also cancel the sleep mode.
DIMMER
The VFD brightness can be adjusted in three ways. Toggle the [DIMMER] button to reduce or restore VFD brightness or completely turn o the display.
NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited
Copyright 2013, NAD Electronics International, a division of Lenbrook Industries Limited
C426_ENG_AD_V02 OCT 2013
1
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ