Owner's Manual

INTRODUCTION

GETTING STARTED

WHAT’S IN THE BOX

Packed with your C 426 you will nd

· An AM loop antenna.

· A FM ribbon-wire antenna with balun.

· A detachable AC power cord.

· An audio cable connector (RCA-to-RCA lead).

· The TNR 1 remote control with 2 (two) AAA batteries.

· This owner’s manual version in CD-ROM.

SAVE THE PACKAGING

Please save the box and all of the packaging in which your C 426 arrived.

Should you move or otherwise need to transport your C 426, this is by far

the safest container in which to do so. We’ve seen too many otherwise

perfect components damaged in transit for lack of a proper shipping

carton, so please: Save that box!

CHOOSING A LOCATION

Choose a location that is well ventilated (with at least several inches to both

sides and behind), and that will provide a clear line of sight, within 23 feet/7

meters, between the C 426’s front panel and your primary listening/viewing

position—this will ensure reliable infrared remote control communications.

Avoid placing the unit in direct sunlight or near sources of heat and damp.

It is perfectly possible to stack the C 426 on top of other components.

QUICK START

In case you simply cannot wait to experience the performance of your

new C 426, we provide the following “Quick Start” instructions to get you

underway.

Please make all the connections to your C 426 with the unit unplugged. It is

also advisable to power down or unplug all associated components while

making or breaking any signal or AC power connections.

1 Use the RCA-to-RCA lead to connect the left and right output of the

C 426 to the tuner input of your amplier.

2 Connect AM and FM antenna.

3 Connect the supplied AC cord to the C 426 AC mains input and then

plug into an AC outlet. The Standby LED indicator embedded around

the bezel of the STANDBY button will illuminate amber.

4 Plug the AC mains plug also of your amplier into the AC outlet. Power

up your amplier and set it to the tuner input where the C 426 is

connected.

5 Press the front panel STANDBY button to turn ON the C 426. The

Standby LED indicator will turn from amber to blue and illuminate the

VFD.

6 Toggle front panel’s [FM/AM] button to select AM or FM band.

7 Toggle front panel’s [PRESET/TUNE] button to switch between “Preset”

and “Tune” mode. Select TUNE mode (“TUNE” scrolls through the VFD).

8 Rotate the [PRESET/TUNE] control knob to select desired station.

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ