Owner's Manual
11 PRESET/TUNE CONTROL KNOB: The function of this control knob
depends upon the selected tuning mode via the PRESET/TUNE button.
Toggle [PRESET/TUNE] button to switch between “Preset” and “Tune”
mode.
a. Preset mode: Rotate the PRESET/TUNE control to the left to scroll
to a lower Preset number; rotate the PRESET/TUNE control to the
right to scroll to a higher Preset number. This is a “wrap-around”
function – upon reaching the last stored Preset number, preset
search will continue on with the rst stored Preset number and vice-
versa. Unused preset numbers are skipped over.
b. Tune mode: Rotate the PRESET/TUNE control in either direction
for more than 1 second to engage automatic tuning. The tuner will
stop at the next suciently strong signal it encounters. Note that
this function “wraps” – that is, it will continue to search from one end
of the AM or FM band to the other until it stops at a strong signal.
Rotate the PRESET/TUNE control again for more than 1 second to
start searching again.
By briey rotating the PRESET/TUNE control in either direction, manual
tuning is engaged for precise tuning to a specic frequency. With each
brief rotation, the tuner will take 0.05 MHz steps at FM band and 10
kHz (120V version) or 9 kHz (230V version) at AM band. When tuned
accurately to a station, “TUNED” will be illuminated in the VFD. The
antenna bars displayed below the ANTENNA icon in the VFD reects the
signal strength of the tuned station.
Automatic tuning is available on both AM and FM band.
IDENTIFICATION OF CONTROLS
FRONT PANEL
7
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ