Owner's Manual

NAD IPD 2
The NAD IPD 2 has its own remote control - the DR 1. When using the
DR 1 to command your iPod player docked in the NAD IPD 2, you have to
refer to your iPod player’s own display screen to make full use of its feature;
there is no OSD at this condition. However, any time you press HTRM’s [S]
button, the “Menu Select” OSD comes up. If you select “iPod Menu” at this
“Menu Select” option, the NAD IPD 2 gets manually connected. The control
of the NAD IPD 2 will then again be done through the M15 HD using the
applicable front panel control buttons or HTRM buttons while referring to
the OSD; the NAD IPD 2 will not respond to any DR 1 commands at this
stage.
IMPORTANT NOTES
• ForyoutocontroltheNADIPD2usingtheDR1,youhavetogoto“iPod
Setup”menu(pleaserefertotheitemabout“iPodSetup”underthe
“USINGTHEM15HD-SETUPMENU”segmentofOPERATIONsection)
andthenset“AutoConnect”to“No”.Withthissetting,youcanthenuse
theDR1tocontrolyouriPodplayerdockedintheNADIPD2.
• Notethatifyouset“AutoConnect”to“No”whileatSource4(iPod),
youhavetochangesourceandthenreturntoSource4(iPod)forthe
changedsettingtotakeeect.
REGAIN CONTROL OF NAD IPD 2 USING DR 1 REMOTE CONTROL
In order to switch back control of the NAD IPD 2 from the M15 HD/HTRM to
the DR 1 remote control, follow these steps.
1 Exit from the iPod Menu by pressing repeatedly [ A ] until it brings you
to “Menu Select” OSD.
2 Highlight “iPod Menu” and press [ A ] to advance to “iPod Menu”.
3 At “iPod Menu”, press [ S ] to close iPod menu. DR 1 remote control
regains control of the NAD IPD2.
In addition to the above commands common to the DR 1, below are the
descriptions of the other DR 1 control buttons.
LIGHT
Press [LIGHT] to turn ON the backlight of your iPod player if it is at idle
mode.
MENU
Press [MENU] to return to previous option or menu selection
ENTER
Press [ENTER] to select an option or start playback.
m REPEAT
Toggle to initiate repeat mode as follows - repeat one song, repeat all songs
or cancel repeat mode
, RANDOM
Toggle to initiate playback in random order. There are three random modes
- Shue Song, Shue Album or Shue O.
9/0
• During playback mode, press [0] to skip forward to the next song or
[9] to skip back to the previous song.
• During playback or pause mode, press and hold [9/0] for fast
forward or backward scanning of current song. Release [9/0] to
resume playback.
TO VIEW VIDEOS OR PHOTOS LOADED IN YOUR iPod
Videos or photos uploaded in your iPod can be viewed directly via the
M15 HD. The following are the steps
1 Make sure that the “TV Out” setting of your iPod’s Video Settings menu is
at “On” mode and appropriate “TV Signal” is chosen.
2 Video or photo le selections and playback procedures are managed
directly from your iPod player and not through the M15 HD. You must
exit completely from the M15 HD’s Setup Menu or Menu Select OSD for
you to be able to navigate through your iPod player’s video or photo
menu options. A more direct way is by going to the “iPod Setup” menu
and set “Enabled” to “No”.
3 With the NAD IPD’s S-VIDEO OUT and AUDIO OUT ports connected
to the M15 HD’s AUDIO 4/S-VIDEO 4 input or to any other assignable
input, you can now directly enjoy via M15 HD your video or photo
le selections as uploaded in your iPod. Make sure that you select the
correct “Source Number” of the M15 HD. Note that if “Enabled” from
“iPod Setup” is set to “No”, ensure that Source 4 is enabled and analog
audio and video settings are assigned to “A4” and “S4” respectively.
NOTE
 Forothernavigationfunctions,pleaserefertoyouriPodplayer’sowner’s
manual.DependingontheiPodplayermodel,someotherfunctions
maybecontrolledusingtheapplicableM15HDnavigationcontrols.
iPod is a trademark of Apple, Inc., registered in the U.S. and other countries.
OPERATION
LISTENING TO YOUR iPod PLAYER
32
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ