Owner's Manual

MODE: The following backlight modes are available:
• O: The backlight will never come ON.
• Sense: The backlight will only come ON if the light sensor detects low
light conditions. See also“SENSE LEVEL discussion below.
• On: The backlight will come ON any time a key is pressed.
SENSE LEVEL (Sen Lvl): The point where the backlight comes ON in a
darkened room. To set this level, go to a dim area where you think the
backlight should be activated given such a dark environment condition.
Then, press [ENTER] at “B Light – Sen Lvl” menu. The display will show the
current sensitivity level. An example is below
If such sensitivity level is alright with you, press [ENTER].
Select YES” to complete the setting of the sensitivity level.
LIBRARY
The HTRM can store a dierent library of default NAD codes for each of its
DEVICE SELECTOR pages. If the original default library does not control
your NAD CD player, DVD player, or other component, follow the procedure
below to change the library code. Please refer as well to the table below for
a list of uploaded NAD Library Codes.
Example: Load NAD DVD Player T 585 library codes to HTRM’s “DVD” device.
1 Press [DVD] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ 6 ] to
scroll to “Library.
3 Press [ENTER].
4 The library code for NAD T585 is “600”. Use [ 3 ] to toggle to “600”. Press
[ENTER].
5 Use [ 3/4 ] to select between “No” (desired library code is not
uploaded) and “Yes” (desired library code is uploaded and saved to the
applicable device page.
NOTE
Insteadofscrollingthroughthelibrarylist,youcanalsokey-indirectly
thelibrarycodebasedonthelistofLibraryCodesbelow.
LIBRARY
CODE
NAD PRODUCT
DESCRIPTION
LIBRARY
CODE
NAD PRODUCT
DESCRIPTION
100
Receiver/Processor (Discrete
ON/OFF)
300 Tuner
101
Receiver/Processor (Toggle
ON/OFF)
301 L75, L76 Tuner
102 S170 302 L70 Tuner
103 L75 303 L53 Tuner
104
Second Zone Commands
(Zone 2)
304 L73 Tuner
3112 Zone 3 305 C425
4112 Zone 4 306 C445
105 L70 307 Txx5 Series Tuner
106 L76 400 Tape Deck B
107 118 401 TAPE Deck A
108 L53 500 TV 280
109 L73 501 MR13
110 Stereo Receiver / Amplier 502 MR20
111 Stereo Second Zone 503 PMR45
112 Txx5 Series 600 T535, T562, T585, M55
200 CD Player 601 T550, L55
201 CD Player (old) 602 T512, T531, T532, T571, T572
202 5170, 5240, 5340 603 L70, L73 DVD
203 5325 604 L56
204 5060 605
T513, T514, T515, T517, T524,
T533, T534
205 M5 606 L53 DVD
LEARN
This function allows you to learn IR commands from another remote.
Example: Learning “MENU” function from a TV remote control into the
MENU button of HTRM’s TV device.
Begin by positioning the HTRM nose-to-nose” with the source remote so
that the two devices’ infrared windows are about 2 inches apart.
1 Press [TV] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ 6 ] to
scroll to “Learn.
OPERATION
USING THE HTRM REMOTE CONTROL
35
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ