Owner's Manual

ENGLISH FRANÇAIS

DEUTSCH

NEDERLANDS

ESPAÑOL

ITALIANO

PORTUGUÊS

SVENSKA

10. BI AMP: Press the BI AMP button to toggle through the filter sequence. A press longer

than one second will advance the crossover frequency selection as follows; BIAMP

CROSSOVER FULL RANGE, HIGH PASS 40 Hz, HIGH PASS 60 Hz, HIGH PASS 80 Hz, HIGH

PASS 100 Hz, and then return to FULL RANGE. Release the BI AMP button to stop the

sequence.

11. DVD/CD Switch: Inside the battery compartment is a selection switch for the M3 remote

control (see figure 4). Position 1-setting controls the NAD DVD-players while position 2-

setting controls NAD CD-players. Using a paper clip, select either position 1 or 2 taking

care not to damage the switch with excessive force.

12. Navigation/Transport Buttons (DVD): With the DVD/CD Switch set to the position 1-

setting the navigation buttons and ENTER will allow navigation of DVD on

screen menus. The TITLE, MENU, DISP (display), and RTN (return) buttons function as

they do on an NAD DVD's remote control.

The transport buttons now control NAD DVD-players.

12. Navigation/Transport Buttons (CD): With the DVD/CD Switch set to the position 2-

setting the navigation buttons will be inoperative. The TITLE button will become a Repeat

function button, the MENU button will become a Random function button, and the DISP

button will become a Time function button. The transport buttons now control NAD CD-

players.

ZR3 REMOTE CONTROL HANDSET (FIGURE 5)

1. ON/OFF: The M3 must be in its on-state in order to use the ZR3 remote control. Press ON

to turn on the REC/Z2 output; press OFF to turn off the REC/Z2 output. Once the REC/Z2

output is on, one can select the source inputs.

NOTE: the REC/Z2 output is a fixed line level output. The volume control of the M3 does not

control the level of this output.

2. Source Buttons: There are 8 source buttons for direct input selection, press the appropriate

input button once the REC/Z2 is in the on-state.

3. SOURCE: Press the or buttons to select the input as the recording source. A

press longer than one second will advance the source selection to the next input as follows;

OFF RECORD, DISC RECORD, CD RECORD, TUNER RECORD, INPUT 4 RECORD, INPUT 5

RECORD, INPUT 6 RECORD, BALANCED RECORD, LOCAL RECORD, and then return to OFF

RECORD. Release the or buttons to stop the sequence.

4. LOCAL: Press this button to directly select the source the main zone is set to. The REC/Z2

output will automatically follow the input selection.

About the M3 Dual Mono Integrated Amplifier:

Operation

M3 10262005.qxd 1/3/2006 2:50 PM Page 16