Owner's Manual

17
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
TROUBLESHOOTING
Reference
Problem Cause Solution
NO SOUND • Power AC lead unplugged or power not
switched on
• Incorrect Mode selected
• Mute on
• Rear Pre-out/Main-in amp links not fitted
• No speakers selected
• Check if AC lead is plugged in and power
switched on
• Select Stereo Mode
• Switch off Mute
• Fit links
• Select the appropriate speakers (A / B)
NO SOUND ONE CHANNEL • Balance control not centred
• Speaker not properly connected
or damaged.
• Input lead disconnected or damaged
• Mode selected to Left or Right or Mono channel
• Centre Balance control
• Check connections and speakers
• Check leads and connections
• Select Stereo Mode
WEAK BASS /
DIFFUSE OR NO STEREO IMAGE
• Speakers wired out of phase
• Biamp mode selected with high pass filter
• Mode set to Left or Right or Mono channel
• Check connections to all speakers in the system
• Set biamp to FULL RANGE
• Select Stereo Mode
REMOTE CONTROL HANDSET NOT WORKING • Batteries flat, or incorrectly inserted
• IR transmitter or receiver windows obstructed
• IR receiver in direct sun or very bright ambient
light
• ZR3 remote used with M3 in Standby.
• Check or replace batteries
• Remove obstruction
• Place unit away from direct sun, reduce amount
of ambient light
• Turn on M3. M3 must be in ON to use ZR3.
POWER/PROTECTION LED STAYS RED UPON
TURNING POWER ON
• Loudspeakers cabling has a short-circuit • Turn amplifier off and check loudspeaker cable
connections for both speakers at amplifier's back
panel and loudspeakers. Turn amplifier on.
POWER/PROTECTION INDICATOR TURNS RED
DURING OPERATION
• Amplifier has over-heated.
• Overall impedance of loudspeakers too low
• Turn amplifier off. Make sure ventilation slots on
top and bottom of amplifier aren't blocked. After
amplifier has cooled down, turn back on.
• Ensure the overall loudspeaker impedance isn't
below 4 ohms.
• Check loudspeaker cables for short circuits
M3 10262005.qxd 1/3/2006 2:50 PM Page 17