Owner's Manual

SETUP MENU
The Setup Menu allows one to customize the operation of the T 748 to the
ancillary equipment used in one’s specic AV system. Unless your system
exactly matches the factory defaults, you will need to use the setup menu
to congure the inputs of the T 748.
At Setup Menu, the following are congurable – Source Setup, Speaker
Setup, Amplier Setup, HDMI Setup, Listening Mode Setup, Display Setup,
AV Presets Setup and Auto Power Down Setup.
Follow the guidelines about “DISPLAY THE OSD” and “NAVIGATING THE OSD
AND MAKING CHANGES” to navigate through the menu options and their
sub-menu selections.
SOURCE SETUP
There are three sub-menu items under Source Setup. These are Source
Setup (Normal), Source Setup (Table ) and iPod Setup.
SOURCE SETUP (NORMAL)
The Source Setup (Normal) menu makes it possible to set, allocate or
change the following settings.
SOURCE
The T 748 is equipped with eight congurable Sources. A particular Source
can be enabled or disabled, renamed, assigned analog and digital audio
sources, video sources, A/V Presets among other settings.
These settings can be implemented through the following parameters.
NOTE
Source 5 is defaulted to iPod. Remove the default setting of Source 5 to
iPod via the following procedure
1 Go to “iPod Setup” menu under the “Source Setup” menu. At “iPod Setup”
menu, set “Enabled” to “No”.
2 Then, go back to “Source Setup” menu and select “Source Setup
(Normal).
3 Go to Source 5 and set “Enabled” to “Yes”.
Source 5 can now be congured to any desired settings.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
Select “Yes” to enable the particular Source or “No” to disable the Source.
NAME
A new Name maybe assigned to a Source label. For example, if your BD
player is attached to “Source 1”, it is possible to rename “Source 1” to “BD”.
In order to rename the Source label, scroll to the “Name” parameter. Press
[ S ] to go to the rst character. Then, press [ D/F ] to pick through the
alphanumeric selections.
Press [ S ] to move to the next character and at the same time save the
changes done on the current character. The name can be as long as eight
characters.
The new Name will be shown in the VFD as well as on the OSD.
ANALOG AUDIO
The T 748 has ve analog audio inputs. These analog inputs - Audio 1, Audio
2, Audio 3, Audio Fr (Front) and Audio MP can be variably assigned to each
Source.
Scroll to “Analog Audio” and then press [ S ] and then [ D/F ] to select and
assign an analog audio input to the particular Source.
NOTE
An incoming digital signal present at the assigned digital input will
always take precedence over the assigned analog audio input, even if
both are present. To maintain the analog audio input for the particular
Source, select “O” at the “Digital Audio” setting of the same “Source”
menu.
GAIN
Gain adjustment allows all sources to play back at the same volume level so
you don’t need to adjust the volume every time a new source is selected. It
is generally preferable to reduce the level of the loudest source rather than
making louder the softer sources.
Scroll to “Gain”, press [ S ] and then [ D/F ] to step through the desired level
from -12dB to 12dB.
OPERATION
USING THE T 748  SETUP MENU
17
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ