Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- introduction
- IDENTIFICATION OF CONTROLS
- operation
- USING THE T 787 – MAIN MENU
- USING THE T 787 – SETUP MENU
- SETUP MENU
- CONTROL/HDMI setup
- SOURCE SETUP
- Source Setup (Normal view)
- Source Setup (Table VIEW)
- iPod SETUP
- Speaker Setup
- AUDYSSEY AUTO CALIBRATION
- Speaker Configuration
- Speaker Levels
- Speaker Distance
- Adjusting the Volume
- Adjusting Channel Levels ‘On the Fly’
- Zone Setup
- AMPLIFIER SETUP
- trigger setup
- Listening Mode Setup
- Dolby Setup
- DTS Setup
- DTS Surround Modes
- ENHANCED STEREO
- Display Setup
- A/V PRESETS
- LISTENING TO AM/FM RADIO
- LISTENING TO XM RADIO
- LISTENING TO DAB RADIO
- LISTENING TO YOUR iPod PLAYER
- USING THE HTR 8 REMOTE CONTROL
- Controlling the T 787
- Learning Codes from other Remotes
- Punch Through
- Copy a Command from another key
- Macro Commands
- Button Illumination Timeout
- CONFIGURING THE BACKLIGHT
- Factory Reset
- Delete Mode
- Loading Code-Libraries
- Search Mode
- Checking Code-Library Number
- Summary of the HTR 8 Modes
- USING THE ZR 7 REMOTE CONTROL
- USING IR CHANNEL
- REFERENCE
17 AC MAINS INPUT
• The T 787 comes supplied with a separate detachable mains power
cord. Before connecting the plug to the mains powers source,
connect rmly rst the other end to T 787’s AC Mains input socket.
• Always disconnect the mains power plug from the mains power
source rst, before disconnecting the cable from the T 787’s AC
Mains input socket.
• Connect only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V
version models only) or 230V 50 Hz (for 230V version models only).
18 SWITCHED AC OUTLET
• This convenience outlet can supply switched power to another
component or accessory.
• The total draw of all devices connected to this outlet must not
exceed 120 watts.
• It is powered ON and OFF by the front panel STANDBY button or by
the HTR 8’s ON and OFF keys.
19 POWER
• Supply the AC mains power to the T 787.
• When the POWER switch is set to ON position, the T 787 goes to
standby mode as shown by the amber status condition of the
Standby LED. Press the front panel Standby button or HTR 8 remote
control’s [ON] button to switch ON the T 787 from standby mode.
• If you intend not to use the T 787 for long periods of time (such as
when on vacation), switch o the POWER switch.
• With POWER switched o, neither the front panel Standby button
nor HTR 8 remote control’s [ON] button can activate the T 787.
IDENTIFICATION OF CONTROLS
REAR PANEL
11
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ