NEDERLANDS Owner’s Manual SVENSKA DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH Wireless AirPlay® Music System РУССКИЙ ®
IMPORTANT SAFETY INSTRUCTIONS ENGLISH SAVE THESE INSTRUCTIONS FOR LATER USE FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO EQUIPMENT. FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ 1. Read instructions - All the safety and operating instructions should be read before the product is operated. 2. Retain instructions - The safety and operating instructions should be retained for future reference. 3.
• The BLUE wire must be connected to the terminal marked with the letter ‘N’ or colored BLACK. • The BROWN wire must be connected to the terminal marked with the letter ‘L’ or colored RED • When replacing the fuse, only a correctly rated and approved type should be used, and be sure to re-fit the fuse cover.
INTRODUCTION ENGLISH Thank you for choosing NAD. WHAT’S IN THE BOX The NAD VISO 1 AP is the latest evolution of the VISO 1 Wireless Digital Music System. NAD VISO 1 AP takes the award-winning audio performance of the original NAD VISO 1 and adds the versatility of Wi-Fi and Apple AirPlay. A USB port at the rear is also added to allow direct connection and charging of Apple’s iPhone, iPad or iPod touch.
ENGLISH IDENTIFICATION OF CONTROLS 6 1 2 FRANÇAIS 3 4 5 3 LAN LAN connection must be setup for wired connection to be established. Set up a Wired Ethernet broadband router with broadband internet connection. Your router or home network should have a built-in DHCP server to consummate the connection. • Connect the VISO 1 AP to a network by directly connecting one end of an Ethernet cable to the LAN port of your wired Ethernet broadband router and the other end to VISO 1 AP’s LAN port.
VISO 1 REMOTE CONTROL ENGLISH S Sequentially select through Sources. +/- Increase or decrease loudness level. X Temporarily mutes audio output or restores audio from mute mode. FRANÇAIS The following remote control commands are applicable only in AirPlay mode or when using an iOS device 0 Skip forward to the next song. Skip forward through parts of the current broadcast or song (if applicable). 9 Skip back to the previous song.
FIRST TIME USE Out of the box and connecting the VISO 1 AP to the mains power source for the first time, the “S” indicator will alternately switch to green and red light after initializing. This indicates that the VISO 1 AP is ready to be configured. Refer to the following sections to fully enjoy and appreciate your VISO 1 AP. ENGLISH VISO 1 AP OPERATION 3 Launch Safari and enter http://192.168.1.12 . The VISO 1 AP User Interface menu window will appear. Select Profile Configuration.
VISO 1 AP OPERATION ENGLISH 6 A Warning notice will pop-up. Select OK to save the new settings. ”S” will continuously flash until it turns solid green. Network connection is successfully established with ”S” turning to solid green. Your iOS device (iPad) is now interfaced with the VISO 1 AP. 2 Press and hold “M” and “S”. FRANÇAIS 7 Return to the Wi-Fi settings of your iOS (iPad) device and ensure that it is set to the same network setting as above (NADLAB).
^ FRANÇAIS AIRPLAY AirPlay lets you stream music from your AirPlay-enabled device to the VISO 1 AP. The AirPlay-enabled device and the VISO 1 AP must be in the same network to send and receive streaming audio with AirPlay. This connection could be wired, using Ethernet, or wireless. • After your AirPlay-enabled device and VISO 1 AP are connected to the same network, the Airplay source will detect the VISO 1 AP.
VISO 1 AP OPERATION ENGLISH OPTICAL (S/PDIF) SOURCE Connect OPTICAL IN of VISO 1 AP to the corresponding optical digital output of sources such as CD, DVD or BD players, digital cable box, digital tuners and other applicable components. Toggle “S” until it turns to solid amber (Optical (S/PDIF) mode). FRANÇAIS IMPORTANT NOTES • The optical digital input is 24/96 capable. • The optical digital input accepts PCM audio signal only.
РУССКИЙ SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH
www.NADelectronics.com ©2013 NAD ELECTRONICS INTERNATIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.