Operation Manual
19 POWER SWITCH: The POWER switch supplies the master AC mains
power for the C 165BEE. When this switch is at ON position, the
C 165BEE is in standby mode as shown by the amber status condition
of the standby LED. Toggle the front panel’s STANDBY button to switch
ON the C 165BEE or back to standby mode. If you intend not to use the
C 165BEE for long periods of time (such as when on vacation), switch
the POWER switch to the OFF position. When the POWER switch is at
OFF position, the front panel STANDBY button or SR 8 remote control
cannot activate the C 165BEE.
20 AC MAINS INPUT: The C 165BEE comes supplied with a separate AC Mains
cable. Before connecting the cable to a live wall socket, ensure that it is
rmly connected to the C 165BEE’s AC Mains input socket rst. Connect
only to the prescribed AC Outlet, i.e., 120V 60 Hz or 230V 50 Hz. Always
disconnect the AC Mains cable plug from the live wall socket rst, before
disconnecting the cable from the C 165BEE’s Mains input socket.
21 SWITCHED AC OUTLET (120V version only): This convenience outlet
can supply switched power to another component or accessory. With
the Power switch at the rear panel set to ON position, this outlet is
powered ON or OFF by the front panel STANDBY button or by the SR 8’s
[ON/OFF] buttons. The total draw of all devices connected to this outlet
must not exceed 120 watts.
UNSWITCHED AC OUTLETS (120V version only): Mains power is
always available at this outlet as long as the AC cord is connected to
AC Main input and plugged in to a live AC wall outlet. This outlet can
be used for components which may require continuous supply of AC
mains; some tuners require uninterrupted mains supply to retain preset
memory, for instance. The total draw of all devices connected to this
outlet must not exceed 360 watts.
NOTE
Never connect the mains lead of a power amplier to either the
SWITCHED or UNSWITCHED outlets.
IDENTIFICATION OF CONTROLS
REAR PANEL
9
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ