Operation Manual

BASS, TREBLE, BALANCE
Bass and Treble controls only aect the low bass and high treble leaving
the critical midrange frequencies free of coloration.
• Use [a/s] to boost or cut Bass or Treble levels within ±7 dB range.
Balance control adjusts the relative levels of the left and right speakers.
• Press [s] to shift the balance to the right or [a] to shift the balance to
the left. Use [a/s] also to recover or even out the balance levels.
• “0 dB” level setting provides equal level to the left and right channels.
FILTERS
Filters provide easy bi-amplication or subwoofer integration by adding the
required lters to redirect bass frequencies to the subwoofer.
High Pass: Low pass signal up to 300 Hz is attenuated and over 300 Hz
sent to the speakers.
Full Range: Refers to the whole frequency spectrum capability of your
C 368 and speaker system. This is ideally 20 Hz to 20 kHz.
PRE OUT/SUBWOOFER
Pre Out/Subwoofer feature allows you to select the function of the PRE-
OUT or SUBWOOFER terminals.
Pre Out: Congured as Pre Out terminals.
Subwoofer: Congured as Subwoofer terminals.
SPEAKER CHANNEL
SPEAKER CHANNEL enables you to engage or disengage the speakers
connected respectively to the SPEAKERS A and SPEAKERS B terminals on
the rear panel.
Select “Speaker A” or “Speaker B” individually and then set to “On” or “O”.
On: Selected speaker is enabled.
O: Selected speaker is disabled.
TEMPORARY DISPLAY
Temporary Display feature enables the display to be turned o temporarily
after 10 seconds of non-user interface.
On: Display is turned o temporarily after 10 seconds of non- user
interface. The Standby LED is also turned o at the same time. Display
and Standby LED are activated once user interface is initiated.
O: Display remains illuminated.
DIMMER
DIMMER function makes it possible to adjust the brightness level of the
front panel display.
Bright: Above normal level of display brightness.
Normal: Normal level of display brightness.
Dim: Below normal level or dimmer than normal display brightness.
NETWORK STANDBY
Network Standby mode maintains network connection at standby mode
with reduced system performance level.
On: Network connection is maintained at standby mode.
O: Network connection is disconnected at standby mode.
Refer also to table below about “OPERATING MODE TRIGGER POINTS”.
OPERATION
USING THE C 368
Balance
SettingsSource Setup
0 dB
+-
Settings
Filters
SettingsSource Setup
High Pass
Settings
Pre Out/Subwoofer
SettingsSource Setup
Pre Out
Settings
Speaker Channel
SettingsSource Setup
Speaker A
Settings
Bass
SettingsSource Setup
0 dB
+-
Settings
Treble
SettingsSource Setup
0 dB
+-
Settings
Dimmer
SettingsSource Setup
Bright
Settings
Temporary Display
SettingsSource Setup
Off
Settings
Network Standby
SettingsSource Setup
Off
Settings
13
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ