Operation Manual

BT WORK MODE
Bluetooth (BT) Work Mode denes the two roles of the C 368 as either a
Bluetooth Sink or a Bluetooth Source.
Sink: Audio stream is received from a Source on the same Bluetooth
network environment.
Source: Audio is streamed or sent to another device (Sink) on the same
Bluetooth network environment.
IMPORTANT NOTE
If the optional MDC BluOS module is installed, the following are
defeated or becomes not selectable
• “Bluetooth” as a Source.
• “BT Work Mode” menu option.
Use instead the Bluetooth option included in the MDC BluOS module.
C368 AS A BLUETOOTH SINK
Set “BT Work Mode” to “Sink”. Initiate pairing of your Bluetooth device with
C 368 by following below procedure.
1 Ensure that the Bluetooth antenna is connected to the BT antenna
terminal at the rear panel.
2 Select “Bluetooth” as a Source. Display shows “Discoverable”.
3 Using your iOS or Android device, go to Settings – Bluetooth and then
scan for Bluetooth devices.
4 At “Discoverable” mode, the unique device ID of your C 368 is listed or
selectable in the device list of your Bluetooth settings. Pair or connect
your C 368 and Bluetooth device.
5 Upon successful pairing of your Bluetooth device and the C 368, display
will change to “Connected” and then “Playing” when music is played
from your Bluetooth device.
NOTES ABOUT BLUETOOTH SINK SETTINGS
1 If you turn OFF the Bluetooth connection (not “unpair” or disconnected)
of your Bluetooth device, the display will change to “Connectable”.
When you turn ON again your Bluetooth device, the display remains
“Connectable”.
“Connectable” means only the same or current Bluetooth device can
connect to your C 368. This prevents other Bluetooth devices from
connecting to your C 368 unless current Bluetooth device is unpaired
or disconnected.
2 From the device list of the current Bluetooth device, select again the
unique device ID of your C 368 and connection will be resumed again
(Connected) and playback can be resumed also.
3 For other devices to connect to your C 368 even if current Bluetooth
device is not unpaired or disconnected, press and hold the [ENTER]
button until the display changes from “Connectable” to “Discoverable”.
Any Bluetooth device can then select and connect/pair to the unique
device ID of your C 368.
C368 AS A BLUETOOTH SOURCE
Set “BT Work Mode” to “Source”. Ensure that the Bluetooth antenna is
connected to the BT antenna terminal at the rear panel.
1 Select “Bluetooth” as a Source. Display could show any of the following
Connectable/Discoverable: C 368 is open to connect or pair with
other Source devices within the same Bluetooth network environment.
By default, no connectable or discoverable Bluetooth devices will be
shown as the unit hasn’t gone to “Inquiring” mode yet.
2 Press and hold ENTER button to set the unit to “Inquiring” mode. The
unit searches for available Bluetooth devices within the same Bluetooth
network environment.
3 Toggle a or s to select through available Bluetooth sources.
4 Connect to your preferred Bluetooth device by pressing ENTER again.
OPERATION
USING THE C 368
BT Work Mode
SettingsSource Setup
Sink
Settings
Bluetooth(Sink)
Discoverable
SettingsSource Setup
Bluetooth(Sink)
Connected
SettingsSource Setup
Bluetooth(Sink)
Playing
SettingsSource Setup
Bluetooth(Source)
Connectable
SettingsSource Setup
Bluetooth(Source)
Inquiring
NAD HP70
SettingsSource Setup
Bluetooth(Source)
Connected
NAD HP70
SettingsSource Setup
16
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ