Operation Manual

5 If you would like to disconnect from current Bluetooth device, press
ENTER again. The unit will switch back to “Connectable…” mode with
searchable/connectable Bluetooth devices now shown.
6 Repeat steps 3 and 4 above to select and connect to another Bluetooth
device.
7 Having settled on a Bluetooth Source device, toggle a SOURCE s to
select the source media you would like streamed to the connected
Bluetooth device. For example, if you want to stream audio from
LINE1, select LINE 1 as the active source.
VOLUME DISPLAY MODE
Volume Display Mode gives the user two options on how to display
Volume level. Use a or s to select between “Decibel” and “Percent” Volume
level display mode.
FIRMWARE VERSION
Firmware version details of Main (MCU), VFD (display) and BT (Bluetooth)
are shown. If MDC BluOS module is installed, BT rmware version detail will
not be shown.
FIRMWARE UPGRADE
Select Firmware Upgrade to initiate VFD Upgrade or BT Upgrade. At each
upgrade mode, select “Yes” to start upgrade process or “No” to retain current
rmware.
MDC CARD UPGRADE
MDC CARD UPGRADE identies and shows the MDC modules installed at
the MDC slots in the rear panel.
A software upgrade of an installed MDC module like the DD USB 2.0 can
be initiated via the MDC Card Upgrade menu. Upgrade the installed DD
USB 2.0 by complying with the DD USB 2.0 software upgrade guideline that
comes with the software upgrade le.
NOTE
An installed MDC BluOS module cannot be upgraded in this menu. MDC
BluOS module upgrade can be facilitated via the BluOS app or “BluOS
Setup” menu.
OPERATION
USING THE C 368
Volume Display Mode
SettingsSource Setup
Decibel
Settings
Bluetooth(Source)
Connectable
NAD HP70
SettingsSource Setup
MDC Card Upgrade
SettingsSource Setup
Slot:2 BluOS
Settings
Firmware Upgrade
SettingsSource Setup
VFD Upgrade
Settings
Firmware Version
Main:V1.39
VFD :V1.13
BT :V1.13
SettingsSource Setup Settings
17
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ