User Manual

SAMPLE SETUP OF TWO NAD PRODUCTS ON THE SAME ZONE
NAD C 368 and NAD C 390DD are both defaulted to Channel 0. If [OFF]
button is pressed on the SR 9 remote control (or AVR 4 remote control for
the C 390DD), both products will go to standby mode. Press [ON] and both
products will power up from standby mode.
To prevent both products from simultaneously going in and out of standby
mode along with other common commands, set each one to a dierent
IR channel. In this setup, we will keep C 390DD and AVR 4 remote control
defaulted to “Channel 0”. As for C 368, we will assign it to “Channel 1”; the
same applies to SR 9.
Set C 368 and SR 9 to “Channel 1” via the following procedure.
C 368
While at “IR Channel” menu, use the [a/s] to go to “Channel 1” setting. Press
[ENTER] to select “Channel 1”.
SR 9
• Press and hold [AMP] in the DEVICE SELECTOR section of the SR 9.
• While holding down the device button [AMP], press “1”, “1” and “0” using
SR 9’s numeric buttons.
• Press [ENTER] while still holding down the device button [AMP]. The
AMP device selector will ash once to indicate that the library input is
successful.
With both C 368 and SR 9 set to “Channel 1”, the C 368 can now be
remotely controlled independent of the C 390DD.
NOTE
Performing a Factory Reset for C368 or SR 9 will restore their respective
IR channel setting to “Channel 0”.
IR LEARNING DEVICE
IR Learning Device enables any non-NAD remote control learn AMP and BluOS
basic remote control codes. With the learned codes, the congured non-NAD
remote control can now be used to command or operate the C 368.
HOW TO LEARN REMOTE CONTROL CODES
1 Go to IR Learning Device menu. Select either AMP or BLS.
2 Select AMP and the rst Amp Learning Key appears – VOLUME UP.
3 Press ENTER to select VOLUME UP and initiate learning mode.
4 Direct or point the non-NAD remote control to the IR sensor in the
front panel. Then, press desired button on the non-NAD remote
control where VOLUME UP will be learned. Upon pressing the
designated button, display will turn to “Learned”.
5 “VOLUME UP” is now learned into the designated button. Repeat
the same for the other codes to be learned. The same procedure
applies for BLS learning.
OPERATION
USING THE C 368
IR Learning Device
SettingsSource Setup
AMP
Settings
Amp Learning Key
SettingsSource Setup
VOLUME UP
Settings
VOLUME UP
SettingsSource Setup
Learning...
Settings
VOLUME UP
SettingsSource Setup
Learned
Settings
15
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ