Operation Manual

6 SOURCE p/q
• Toggle through the input selections - Digital Coaxial 1, Digital Coaxial 2, Digital Optical 1, Digital
Optical 2, Digital AES/EBU, Computer, Digital USB Back and Digital USB Front. If the optional
MDC modules are installed, the source selections will include the sources incorporated in the
applicable modules.
7 p VOL q
• Increase or decrease loudness level. Release the button when desired level is reached.
• The front panel display will indicate the volume level as in “Vol: -/+ _ _._ dB”
(“-/+_ _._ ” indicates the numerical dB level).
8 D/F/A/S, ENTER
D/F/A/S : Navigate through the menu options.
D/F : Adjust applicable control levels.
ENTER/S: Display menu options. Select an item in a menu.
A : Return to previous display.
9 DISP
With the optional MDC DD BluOS installed and DEVICE SELECTOR set to AMP, press and hold [DISP]
to turn ON or OFF BluOS Setup menu (“BluOS Setup ON” or “BluOS Setup OFF” is displayed at the
front panel display).
10 TONE
Toggle to select between “Tone Defeat” and “Tone Active” as indicated in the front panel display.
• Tone Defeat: Tone control circuits are bypassed and eectively defeated.
• Tone Active: Tone control circuits are active. At Tone Active mode, toggle [TONE] button to
select “Treble” or “Bass” and then use the [D/F] to adjust their respective levels.
11 EQ
Bring up the adjustable Equalization parameters - Frequency, Level and EQ levels.
AV SURROUND SOUND RECEIVER CONTROL (use with compatible NAD AV Surround Sound
Receiver or Preamplier models)
Set the DEVICE SELECTOR to “AMP” in order to gain access to these buttons. Refer to the corresponding
labels printed in the remote control faceplate and their respective assigned buttons to make use of
these functions. Some of the control buttons below are applicable only to specic NAD AV Surround
Sound Receiver or Preamplier models; check the owner’s manual of your NAD AV Surround Sound
Receiver or Preamplier for control button compatibility.
A/V PSET: In combination with the numeric keys, press a Preset number from 1 to 5 as referenced
to A/V Presets settings. Note that the Preset settings can be congured via the A/V Presets menu.
DIMMER: Reduce or restore front panel display brightness.
TEST: Initiate speaker TEST mode while at the Speaker Levels section of the Speaker Setup menu.
MUTE: Temporarily mute audio output or restore audio from mute mode.
SOURCE [5/6]: Toggle to select through the input sources.
SURR: Select desired listening or surround mode.
D/F/A/S, ENTER: Navigate through the menu options. Adjust applicable control levels.
ENTER/S: Display on-screen Main Menu options.
SLEEP: Switch o unit after a preset number of minutes.
EQ: Display on-screen DSP options.
TONE: Show tone control options on front panel display. Use [D/F] to adjust applicable levels.
L.NITE: Set Dynamic Range Control (DRC) level. Toggle [L.NITE] to select either DTS or Dolby DRC
setting and then use [D/F] buttons to set up DRC level.
IDENTIFICATION OF CONTROLS
AVR 4 REMOTE CONTROL
12
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ