Owner's Manual

2
ADDENDUM SHEET FOR C 427
USING SR 10 WITH C 427
SR 10 is a universal NAD remote control designed to operate several NAD
models including the C 427.
SR 10 will operate up to a distance of 23ft (7m). Two AA batteries should
be fitted in the battery compartment at the rear of the remote control
handset. Ensure that the batteries are correctly oriented and installed as
indicated on the base of the battery compartment.
For SR 10 to operate with C 427, Library code 41 must be loaded to
the AUX device of SR 10. Loading Library code 41 will enable SR 10 to
command C 427 albeit with limited functions.
LOAD LIBRARY CODE 41 TO AUX DEVICE OF SR 10
1 Press and hold AUX in the DEVICE SELECTOR section of SR 10.
2 While holding down AUX device button, press 4 and then 1 using
SR 10’s numeric buttons. 41 is the compatible library code for C 427.
3 Press ENTER while still holding down the AUX device button. The
AUX device selector will flash once to indicate that the library input is
successful. Both the AUX device selector and ENTER buttons can now
be released.
With Library code 41 successfully loaded, start using SR 10 with C 427
by selecting AUX under the DEVICE SELECTOR section.
NOTE
Ensure that the DEVICE SELECTOR is always set to AUX prior to sending
any commands to your C 427.
IMPORTANT
SR 10 has limited library of C 427 remote control commands. Only the
following functions are applicable.
Refer to the corresponding labels printed in the SR 10 faceplate and their
respective assigned buttons to make use of the following functions.
1 ON: Power up C 427 from standby mode
OFF: Switch C 427 to standby mode
2 ENTER: Toggle to select Tune or Preset mode
A/ S (TUNE): Tune forward or backwards
D/F (PRESET): Go to next or previous Preset
3 0-9 number buttons: Direct entry of frequency channel or Preset
number
4 : Reduce or restore front panel display brightness
5 u: Toggle to select AM or FM band
9: Go to previous Preset
0: Go to next Preset
4
5
3
2
1
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without notice.
ADDENDUM SHEET FOR C427  SR9 AND SR10 V07  DEC 2022