Operation Manual

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No power. The power cord is disconnected.
• Plug the power cord into the wall outlet
securely.
•
No sound. Power AC lead unplugged or power not switched ON. • Check AC lead. •
Mute ON. • Switch OFF Mute. •
No sound one channel. Balance control not centered. • Center Balance control. •
Speaker not properly connected or damaged. • Check connections and speakers. •
Input lead disconnected or damaged. • Check leads and connections. •
Weak bass/diused stereo image. Speakers wired out of phase. • Check connections to all speakers in the
system.
•
No sound from Subwoofer. Subwoofer is o, not powered or improperly
connected.
• Power-up subwoofer, check Sub’s AC outlet
or check connections.
•
Noisy reception, hiss. Weak signal. • Check station tuning. Adjust or replace
antenna.
•
Display shows “no service list”. DAB antenna not connected properly. • Check the connection and position of the
DAB antenna.
•
No DAB coverage in the area. • Call your local DAB broadcast providers for
coverage information.
•
Reception with whistling, buzzing
noise.
Interference from other computers, games consoles. • Check station tuning. Switch o or move the
source of electrical noise.
•
No RDS information. Station signal too weak. • Check station tuning. Adjust or replace
antenna.
•
Station not transmitting RDS data. • Tune to an RDS station that supports station-
name (PS mode) and radio-text (RT mode).
•
C 725BEE does not respond to
remote control.
Batteries are at or incorrectly inserted. • Check batteries. •
IR transmitter window on remote or IR receiver
window on C 725BEE is obstructed.
• Check IR windows and ensure clear line-of-
sight from remote to C 725BEE.
•
C 725BEE front panel is in very bright sunlight or
ambient light.
• Reduce sunlight/room lighting. •
NOTES
• Reset C 725BEE to its factory default settings using front panel buttons only (120V version only): Press and hold [SPEAKER A] button and then [TONE
DEFEAT]. “AH Reset…complete.” is shown in the VFD.
• Reset C 725BEE to its factory default settings using front panel buttons only (230V version only): Press and hold [SPEAKER B] button and then [TONE
DEFEAT]. “C Reset…complete.” is shown in the VFD.
• All stored presets and settings will be deleted upon restoring your C 725BEE to its factory default settings.
REFERENCE
TROUBLESHOOTING
20
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ