2/21/2005 ® 12:57 PM Page 1 C720BEE PORTUGUÊS SVENSKA Owner’s Manual Manuel d’Installation Bedienungsanleitung Gebruikershandleiding Manual del Usuario Manuale delle Istruzioni Manual do Proprietário Bruksanvisning ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS Stereo Receiver ENGLISH C720BEE manual (GB).
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS • Save these instructions for later use. • Follow all warnings and instructions marked on the audio equipment. 1 Read instructions - All the safety and operating instructions should be read before the product is operated. ENGLISH 2 Retain instructions - The safety and operating instructions should be retained for future reference.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 3 INPORTANT SAFETY INSTRUCTIONS 19 Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) When the power-supply cord or plug is damaged. b) If liquid has been spilled, or objects have fallen into the product. c) If the product has been exposed to rain or water. ENGLISH d) If the product does not operate normally by following the operating instructions.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 4 ABOUT THE C 720BEE REAR PANEL CONTROLS FRONT PANEL CONTROLSFRONT PANEL CONTROLS ENGLISH 2 1 3 4 SPEAKERS 5 A ANTENNA FRANÇAIS NO RTH AMERICA SWITCHE D Serial No./No. De Series FM GN D AM S PEAKERS 120V B 60Hz 100W/1 A M AX.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 5 ABOUT THE C 720BEE 1 CD VIDEO TAPE 1 TAPE 2 AUX IN 5 IN 6 BAL DISC IN 4 2 2 LOCAL SOURCE TUNER PRESET FM TUNE 6 FRANÇAIS 1 ENGLISH REMOTE CONTROLS DEUTSCH AM ZR 3 3 7 NEDERLANDS 8 4 5 ESPAÑOL 6 DEV1 DEV2 ITALIANO 7 SVENSKA PORTUGUÊS 9 PRESS IN AND LIFT TAB TO REMOVE BATTERY COVER OUT FROM RECESS PLACE BATTERIES INTO OPENING.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 6 ABOUT THE C 720BEE ENGLISH NOTES ON INSTALLATION Your NAD C720BEE should be placed on a firm, level surface. Avoid placing the unit in direct sunlight or near sources of heat and damp. Allow adequate ventilation. Do not place the unit on a soft surface like a carpet. Do not place it in an enclosed position such a bookcase or cabinet that may impede the air-flow through the ventilation slots.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 7 ABOUT THE C 720BEE NOTE: Always turn the amplifier off before connecting or disconnecting anything from to Pre-Out and Main-In sockets. 10 PRE-OUT - Connections to an external power amplifier or processor, such as a surround-sound decoder. In normal use these should be connected to the Main-In sockets (No. 10) with the links supplied. To connect your NAD C720BEE to external processor or amplifier sections first remove these links.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 8 ABOUT THE C 720BEE FRONT PANEL CONTROLS ENGLISH 1 Power - Press the POWER button to switch the unit from Stand-by to the operating mode; The Stand-by indicator (Fig. 2; No. 2) will turn from amber, to red, then to green. Press the POWER button to switch the unit to the Stand-by mode: The Stand-by indicator will light up amber.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 9 17 SPEAKER A & B - The Speakers A and B buttons engage or disengage the speakers connected respectively to the Speakers A and Speakers B terminals on the rear panel. Press A to switch the speakers connected to the speaker A terminals On or Off. Press B to switch the speakers connected to the speaker A terminals On or Off. The indicator directly over the buttons shows the status of both speakers A and B.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 10 ABOUT THE C 720BEE ENGLISH 7 CD PLAYER CONTROL - (for use with NAD CD-Player) | | engages Pause engages Stop engages Play or toggles between Play and Pause or engages Track skip; Press once to respectively go to the next track or to return to start of current or previous track. engages reverse Scan and Skip engages forward Scan and Skip.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 11 CHOOSING THE BLEND MODE Weak or remote stereo radio stations are sometimes received with noise and hiss as the antenna signal is too weak. Switching the tuner to mono will reduce the amount of noise and hiss but at the expense of any stereo information. The NAD Blend feature will allow you to reduce the amount noise and hiss but still retain some level of stereo separation, instead of mono.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 12 SPECIFICATIONS PRE-AMP SECTION LINE LEVEL INPUTS(DISC, CD, VIDEO, AUX, TUNER, TAPE) Input impedance (R and C) Input sensitivity (1V out) ENGLISH Maximum input signal Signal / noise ratio pre-amp out, A-weighted Frequency response 20Hz - 20kHz 22kΩ+ 100pF 330mV 6V 106dB ref. 500mV <±0.1dB (Tone defeat on) <±0.5dB (Tone defeat off) THD + Noise, SMPTE IM < 0.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 13 SPECIFICATIONS TUNER SECTION Input sensitivity Mono: 16.1dBf 50dB Stereo: 36.1dBf Harmonic Distortion; Signal / noise; Signal / noise; Stereo separation at 1kHz; Frequency Response; FM Mono: 0.3% FM Stereo 0.5% ENGLISH Harmonic Distortion; Mono 60dB Stereo 55dB 40dB ± 1.5dB 30Hz - 15kHz Dimensions (W x H x D) Net weight Shipping weight FRANÇAIS PHYSICAL SPECIFICATIONS 435 x 147 x 387mm 8.7kg (19.2lb) 11.4kg (25.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 14 TROUBLESHOOTING PROBLEM NO SOUND CAUSE ENGLISH FRANÇAIS DEUTSCH NEDERLANDS • • • Power AC lead unplugged or power not switched on Tape Monitor selected Mute on • • Check if AC lead is plugged in and power switched on De-select Tape Monitor mode Switch off Mute NO SOUND ON ONE CHANNEL • • Speaker not properly connected or damaged.
C720BEE manual (GB).qxd 2/21/2005 12:57 PM Page 15 www.NADelectronics.com ©2005 NAD ELECTRONICS INTERNATIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved.