Owner's Manual

ENGLISH

OPERATION

LOAD PRESETS

Select LOAD PRESET(S) to upload saved Preset settings/les to your

amplier. Undertake the following steps to LOAD PRESET(S).

1 Select “Load Preset(s)” to load a saved Preset le to a desired Preset

number.

2 Select “Single Preset” if you want to load saved Preset les one at a time

or “All Presets” to load saved “All Presets” at the same time. Find and

select from the Preset le’s location/directory the Preset number(s)/les

you would like to load to your amplier.

3 “Upload Complete” will be shown each time a Preset le or “All Presets”

le is successfully uploaded. Slope, Q, Frequency and Gain settings are

recalled, loaded and reected in the frequency response graph upon

selection of a Preset le. Check loaded Preset(s) by selecting Preset

Editing $ Editing $ Preset number.

PRESET EDITING

DUPLICATE/FROM/TO

• Select FROM drop down tab the Preset number you will copy TO

another Preset number. For example, select “Preset 1” from FROM drop

down tab and then select from TO drop down tab “Preset 2”. Afterwards,

select “DUPLICATE” to complete the copying of Preset1 settings to

Preset 2. Current Preset 2 settings (if available) will be replaced by Preset

1 settings.

EDITING

• Use to set Slope, Q, Frequency and Gain settings and assign/save to a

particular Preset. Refer also to SAVE PRESET(S) above.

RENAME

• From the EDITING drop down tab, select the Preset number you

would like to rename. Upon selection of the Preset number, type in

the RENAME section the Preset name you would like to call the Preset

number and press ENTER.

RESET

• Selecting RESET will restore current Preset number to default settings.

TEST SIGNAL

A test signal can be sampled or loaded through all the channels. This is

useful for checking audio level of each channel or comparing/balancing

audio levels among the channels.

CHANNEL

• Select from the drop down tab the channel where test signal will be

loaded. The test signal can be assigned to Channel 1 up to Channel 8 or

select ALL for the same test signal to be loaded to all eight channels at

the same time.

TEST SIGNAL

• Select ON for the test signal to be active for the selected channel. Turn

o test signal by selecting OFF.