Owner's Manual

ENGLISH
PERFORM IR LEARNING WITH TV REMOTE CONTROL
Direct or point the D 3045 or TV remote control to the D 3045 front screen when performing below procedure.
IR LEARNING PROCEDURE
STEP** PROCEDURE D 3045 FRONT SCREEN DISPLAY
1 Press and hold [MUTE] of AMP 3 remote
control to initiate IR learning mode.
LEARNING
Choose
One Key
2 Press [ON] of AMP 3 remote control.
LEARNING
Power
3 Press [ON] of TV remote control.
LEARNING
Press
Again
4 Press again [ON] of TV remote control.
LEARNING
Power OK
Next Key
5 Repeat Steps 2 to 4 to learn “Volume +”,
“Volume - “ and “Mute” controls.
Learning “Vol +”. Press corresponding remote control button as indicated.
[Vol +] of AMP3 remote control [Vol +] of TV remote control [Vol +] of TV remote control
LEARNING
VOL +
$
LEARNING
Press
Again
$
LEARNING
VOL + OK
Next Key
Learning “Vol - ”. Press corresponding remote control button as indicated.
[Vol -] of AMP3 remote control [Vol -] of TV remote control [Vol -] of TV remote control
LEARNING
VOL -
$
LEARNING
Press
Again
$
LEARNING
VOL - OK
Next Key
Learning “MUTE”. Press corresponding remote control button as indicated.
[MUTE] of AMP3 remote control [MUTE] of TV remote control [MUTE] of TV remote control
LEARNING
MUTE
$
LEARNING
Press
Again
$
LEARNING
MUTE OK
Next Key
6 Press and hold “MUTE” to stop, complete or exit learning mode. Normal operation resumes. Any learned functions before exiting learning mode are retained and saved.
* Dependent upon the D 3045 going rst to network standby mode after 30 minutes of inactivity.
** Power ON, Vol+, Vol- and Mute can be learned in any order or sequence.
OTHER FEATURES
12
TURN OFF TV’S INTERNAL SPEAKERS (IF SO EQUIPPED)
It is recommended that you disable the TV’s internal speakers so that only
the D 3045 is heard. This setting is usually accessible from the TV’s Setup
Menu. Consult your TV’s Instruction Manual for instructions specic to your
make and model of TV.
CLEAR LEARNED IR CODES
To delete learned IR codes
• Press and hold D 3045 remote control’s [MUTE]. When “LEARNING...
Choose One Key” is shown, press and hold again [MUTE]. Learned IR
codes are deleted when the display exits the learning mode screen and
returns to the current source.
□
□
□
□
□ □ □
□ □ □
□ □ □