Owner's Manual

Table Of Contents

ENGLISH

AMP 3 REMOTE CONTROL

1 ON: Power up unit from Standby mode to operating mode.

OFF: Switch unit to Standby mode.

2 SOURCE d/f: Select through source input selections.

3 DIM: Toggle to select display brightness level – dim, bright or display

turned o.

4 MUTE: Audio is temporarily switched o or restored. Restore audio by

pressing MUTE again, VOL d/f or rotating VOLUME knob.

5 VOLUME d/f: Increase or decrease loudness level.

6 BASS: Toggle to select BASS EQ, HP 120Hz, HP 80Hz or HP 40Hz.

• Bass EQ boosts overall bass response by at least 6 dB.

• HP 120Hz, HP 80Hz or HP 40Hz attenuates signal below the

indicated cuto frequency and allow higher frequencies to pass

through.

• Press and hold BASS button until BT ON (Bluetooth discoverable) or

BT OFF (Bluetooth invisible) is shown in the display.

7 BLUETOOTH CONTROLS (applicable at BT Receive or Transmit

mode)

4 : Press and hold [4] button to toggle between Bluetooth RECEIVE

and TRANSMIT modes.

9/0 : Use to select through connectable Bluetooth devices at

Bluetooth TRANSMIT mode.

IDENTIFICATION OF CONTROLS

AMP 3

BASSDI M

2 5

■