Owner's Manual

UNPACKING AND SETUP

WHAT’S IN THE BOX

Packed with your D 3020 you will nd:

• Detachable mains power cord

• AMP 3 remote control with 3V CR2025 battery

• 3.5mm plug to single RCA female adaptor

• Four pieces of dome-shaped feet

• Quick Setup Guide

SAVE THE PACKAGING

Please save the box and all the packaging in which your D 3020 arrived.

Should you move or otherwise need to transport your D 3020, this is by

far the safest container in which to do so. We’ve seen too many otherwise

perfect components damaged in transit for lack of a proper shipping

carton, so please: Save that box!

QUICK SETUP

This simple guide will help you get started with your D 3020.

Place the D 3020 on a rm, level surface. Do not place the unit on a soft

surface like a carpet.

Make all the connections to your D 3020 with the unit unplugged from

the mains power source. It is also advisable to power down or unplug all

associated components while making or breaking any signal or AC power

connections.

1 Connect applicable speakers to the LEFT and RIGHT SPEAKERS terminal

of D 3020. These binding post connectors accept both bare wire and

banana plugs.

2 Using applicable patch cords (not supplied), connect Source devices to

corresponding input sockets of D 3020.

• S/PDIF sources: OPTICAL, COAXIAL

• Analog sources : AUX, PHONO

3 If you have a powered subwoofer, use the supplied 3.5mm plug to

single RCA female adaptor connecting the 3.5mm plug to SUBW OUT

and the single RCA female socket to a single RCA cord connected to the

input of external subwoofer.

4 Connect corresponding end of the mains power cord to the AC mains

input of the D 3020 and the plug connected to a mains power source.

5 With all Sources connected to D 3020 and powered up, tap o (Standby)

to switch ON the D 3020 from standby mode. This is an amber colored

touch sensitive switch on the top surface.

6 Press or tap repeatedly “S” until desired Source is highlighted. Rotate

volume control to adjust audio level.

RESTORE D3020 TO FACTORY DEFAULT SETTINGS

Press and hold “BASS EQ” at the rear panel until D 3020 defaults to COAX

source.

GETTING STARTED

ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ