Owner's Manual

OTHER FEATURES
BLUETOOTH AS A SOURCE
Initiate pairing of your Bluetooth device with D 3020 by following below
procedure.
1 Using your iOS, Android or your Bluetooth device, go to Settings –
Bluetooth and then scan for Bluetooth devices.
2 Select the unique device ID of your D 3020 among the available devices
listed in your Bluetooth settings. Pair or connect together your D 3020
and Bluetooth device.
3 Upon successful pairing of your Bluetooth device and D 3020, select “BT”
as a Source to listen to music stream from your Bluetooth device.
UNPAIR BLUETOOTH CONNECTION
Undertake below procedure to unpair or disconnect Bluetooth connection
to D 3020.
1 While at operating mode, press and hold “4” button of AMP 3 remote
control until “BT” begins to ash in the front screen.
2 Release “4” button as “BT” ashes for three times. Bluetooth connection
is cleared and available again for pairing or connection.
ABOUT aptX®
A Bluetooth connection is a bit like a data pipeline between devices.
Because the pipeline has a maximum width, it can sometimes be dicult
to ow large audio les through it. aptX® enables CD-like quality wireless
audio by solving the problem of sending the full music bandwidth
over Bluetooth. aptX® reduces the size of the audio les so they can be
squeezed through the wireless pipeline without aecting the sound quality.
D3020 supports aptX®.
AUTO STANDBY
The D 3020 can be setup to automatically go to standby mode if there is
no user interface interaction and no active Source input within 30 minutes.
Auto standby mode can be enabled or disabled by the following steps.
ENABLE AUTO STANDBY MODE
• While at standby mode, press and hold “OFF” button of the AMP 3 remote
control until all indicators in the front screen wake up and blink once.
• At operating mode and with auto standby enabled, the D 3020
will automatically go to standby mode if there is no user interface
interaction and no active Source input within 30 minutes.
DISABLE AUTO STANDBY MODE
• While at standby mode, press and hold “OFF” button of the AMP 3
remote control until all indicators in the front screen wake up and blink
twice.
• At operating mode and with auto standby disabled, D 3020 will not go
to standby mode at any time unless directly initiated by pressing top
panel’s o (Standby) switch or OFF button of AMP 3 remote control.
AUTO SENSE
Auto sense feature enables the D 3020 to wake up from standby mode
and starts operation by selecting OPTICAL source or the last digital source
before going to standby mode.
CONDITIONS FOR AUTO SENSE
• For Auto Sense to work, Auto Standby must be set to ON with D 3020
going rst to standby mode.
• If IR Learning with TV remote control is successfully completed and with
D 3020 going to standby mode, auto sense is activated upon detection
of active digital input only from OPTICAL input.
− With this condition, D 3020 wakes up and automatically switches to
OPT.
• If no IR Learning is conducted, auto sense is activated upon detection
of active input from the last source (limited only to the digital sources)
before the D 3020 goes to standby mode.
− With this condition, D 3020 wakes up and automatically switches to
the last selected digital source prior to the D 3020 going to standby
mode.
ENABLE AUTO SENSE MODE
• While at standby mode, press and hold “SOURCE d” button of the
AMP3 remote control until o and S icons at the top screen wake up
and blink once.
DISABLE AUTO SENSE MODE
• While at standby mode, press and hold “SOURCE d” button of the
D 3020 remote control until o and S icons at the top screen wake up
and blink twice.
7
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ