System Remote Control Owner's Manual HTR-3

LEARNING CODES FROM OTHER REMOTES
Begin by positioning the HTR 3 “nose-to-nose” with the source
remote so the two devices’ infrared windows are about 2
inches apart.
• Enter Learning Mode: On the HTR 3, simultaneously press-
and-hold for 3 seconds both a DEVICE SELECTOR key and
the [RES] key (just below the DISP key) until the Learn LED
at the center of the HTR 3 turns steady green.
• Press the HTR 3’s function key you wish to teach a
command; the Learn LED will turn amber.
• Press-and-hold the function key on the source remote: The
HTR 3’s Learn LED will icker amber for a second or two,
then turn solid green. The command is learned.
• Press the HTR 3’s DEVICE SELECTOR key again to exit the
learning mode.
If the Learn LED does not icker amber you may need to vary
the distance between the remotes. If the Learn LED turns red
rather than green, that particular command of that source
remote command could not be learned. In rare instances, there
maybe some IR format that is not compatible with the HTR 3.
Example: Learning “DVD Pause”
Position the HTR 3 and your DVD player’s remote as described above.
• On the HTR 3, simultaneously press-and-hold [DVD] and
[RES]; the Learn LED turns steady green.
• Press the HTR 3’s Pause [ ] key; the Learn LED turns amber.
• Press-and-hold the corresponding Pause key of your DVD
player’s remote control; the HTR 3’s Learn LED ickers amber
and then turns solid green. The command is learned.
• Press [DVD] again to exit the learning mode.
CANCEL OPERATION
You can cancel conguring a key, by pressing the active
DEVICE SELECTOR key before the learn process is complete; the
Learn LED will turn red.
PUNCH THROUGH
The HTR 3’s “punch-through” function allows you to retain a
function key from one Device Select “page” to another, so that,
for example, the AMP [SURR MODE] function might still control
the NAD A/V receiver when the DVD DEVICE SELECTOR page
is active.
NOTE
The HTR 3’s [VOL] keys are pre-programmed as “punched-
through” for all Device Select pages: [VOL] will operate the
NAD’s master-volume regardless of the currently selected
device. The [SURR] [CENTER,] and [SUB] Channel Volume
controls similarly are pre-programmed as punched-through.
To set a punch through, after entering the Learning Mode,
and pressing the desired key to be punched through, simply
press the device key twice of the device to punch through to.
The status LED will turn green; press the DEVICE SELECTOR key
again to exit Learning Mode.
Example: Punch-through AMP [SURR MODE] key to the DVD
“page”
• On the HTR 3, simultaneously press-and-hold [DVD] and
[RES]; the Learn LED turns steady green.
• Press [SURR MODE]; the Learn LED turns amber.
• Press [AMP] twice; the Learn LED turns green.
• Press [DVD] again to exit the learning mode.
4
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ
HTR3_eng_OM_v02.indd 4 7/8/07 22:03:26