Operation Manual

The M32 has the following Tone Control levels – Treble, Bass and Balance.

Bass and Treble controls only aect the low bass and high treble leaving

the critical midrange frequencies free of coloration. The Balance control

adjusts the relative levels of the left and right speakers.

h : Slide to adjust treble, bass or balance level.

: Slide to turn ON or OFF Tone Controls. At OFF setting, tone

controls (Treble and Bass) are disabled or defeated – Balance option

remains available.

SETUP

The Setup menu contains the menu options for Speaker Setup, Source

Setup, Digital Output and Control Setup.

SPEAKER SETUP

SPEAKER COMPENSATION

The digital impedance compensation lter provides ne tuning of the

top octave to match your speaker impedance. This results in perfectly at

frequency response at 20 kHz. The eect of this lter may not be audible*

but it is measurable and it compensates for the small eect of the digital

reconstruction lter that eliminates the 844 kHz sampling frequency of the

amplier.

* The exception may be some electrostatic speakers that have very low

impedance at high frequency. The lower the HF impedance, the greater

the deviation from at response.

SUB OUTPUT

At “ON” Setting, all subwoofer settings are in eect. At “OFF” setting, all

subwoofer settings are disabled. With Sub Output set to “ON”, the following

subwoofer settings can be setup.

IMPORTANT

Set the “Sub Output” option under “Speaker Setup” settings to “ON” for

the OUTPUT terminals to function as Subwoofer out. On the other hand,

the OUTPUT terminals will function as PRE-OUT if the “Sub Output”

option is set to “OFF”.

OPERATION

USING THE M32

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ