Operation Manual
INTRODUCTION
GETTING STARTED
QUICK START
Refer to the supplied CI 940 Quick Setup Guide for basic instructions in
setting up your new NAD CI 940. The following important notes must also
be observed when setting up your CI 940.
IMPORTANT SETUP NOTES
· Before setting up or making connections, ensure that the CI 940 and
other devices to be connected to CI 940 are unplugged or powered
down.
· Connect the speaker cables to the supplied speaker connectors by
following the corresponding ZONE 1 (and/or ZONE 2) speaker terminal
connections (R+/-, L+/-) as reected in the CI 940 rear panel.
· Bare wire or loose strands from the speaker cables must not touch the
rear panel or other speaker terminals.
· After installing the speaker cables to the supplied speaker connectors,
plug in the speaker connector to ZONE 1 (and/or ZONE 2) speaker
terminal of CI 940.
· Connect corresponding end of the mains power cord to the AC mains
input of CI 940 and the plug connected to a mains power source.
· Set the POWER switch at the rear panel to “ON” setting. The Standby LED
indicator will illuminate amber. Press the STANDBY button to turn ON
the CI 940. The Standby LED indicator will turn from amber to blue.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your CI 940 arrived.
Should you move or otherwise need to transport your CI 940, this is by
far the safest container in which to do so. We’ve seen too many otherwise
perfect components damaged in transit for lack of a proper shipping
carton, so please: Save that box!
NOTES ON INSTALLATION
· Place your NAD CI 940 on a rm, level surface.
· Avoid placing the unit in direct sunlight or near sources of heat and
damp.
· Do not place the unit on a soft surface like a carpet.
· Do not place the CI 940 in an enclosed position such as a bookcase
or cabinet that may impede the air-ow through the ventilation slots.
Allow adequate ventilation.
· Make sure the unit is switched o before making any connections.
· The RCA sockets on your NAD CI 940 are color coded for convenience.
Red and white are Right and Left audio respectively. Use high quality
leads and sockets for optimum performance and reliability.
· Ensure that leads and sockets are not damaged in any way and all
sockets are rmly pushed home.
· Should water get into your NAD CI 940, shut o the power to the unit
and remove the plug from the AC socket. Have the unit inspected by a
qualied service technician before attempting to use it again.
· Use a dry soft cloth to clean the unit. If necessary, lightly dampen the
cloth with soapy water. Do not use solutions containing benzol or other
volatile agents.
DO NOT REMOVE THE COVER; THERE ARE NO USERSERVICEABLE
PARTS INSIDE.
5
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ